M&R i-Image S User Manual

M&R Companies 440 Medinah Rd. Roselle, IL 60172 USA 39
Tel: +630-858-6101 Fax: +630-858-6134 www.mrprint.com | store.mrprint.com
V.120617
Driver Tab
The Driver tab allows the selection of Print Modes providing you are printing directly to the Amica port/PCS. In
this scenario the Get button (1) is used to access the PCS Print Modes. However in most cases the system will
be configured to print to File which voids the Print Mode selection, leaving that function to the I-Image S operator.
Over Print: The Over Print selection should be set at 1 time (2). Increasing it will slow the printing process, lay
down more ink and possibly cause dot gain issues.
Dot Size: Dot Size refers to the actual ink droplet size being expelled from the printhead. It should be set to
Small Dots (3) which best supports all printing scenarios.

M&R i-Image S Specifications

General

Brand	M&R
Model	i-Image S
Category	Industrial Equipment
Language	English