1 - 24
MACHINE MAINTENANCE INSTRUCTIONS
GENERAL INSTRUCTIONS
- Make sure the area is adequately ventilated before starting up the machine.
- Wear clothes suitable for the maintenance of the machine. Avoid wearing jewelry and loose clothes. Tie back and protect
your hair, if necessary.
- Stop the engine and remove the ignition key before carrying out any work.
- Read the operator's manual carefully.
- Carry out all repairs immediately, even if the repairs concerned are minor.
- Repair all leaks immediately, even if the leak concerned is minor.
- Ensure that process materials and of spare parts are disposed in all safely and in an ecological manner.
- Be careful of the risk of burning and splashing (exhaust, radiator, engine, etc.).
MAINTENANCE
- Perform the periodic maintenance ( MAINTENANCE) to keep your machine in good working condition. Failure to
perform periodic maintenance may invalidate the contractual warranty.
MAINTENANCE LOGBOOK
- The maintenance operations carried out in accordance with the recommendations (
MAINTENANCE) and the other
inspection, servicing or repair operations or modifications performed on the machine or its attachments shall be recorded
in a maintenance logbook. The entry for each operation should include the date of the work, the names of the individuals
or companies having performed them, the type of operation and its frequency, if applicable. If machine elements are
replaced, the part numbers of these elements shall be indicated.
LUBRICANT AND FUEL LEVELS
- Use the recommended lubricants (never use contaminated lubricants).
- Do not fill the fuel tank when the engine is running.
- Only fill up the fuel tank in areas specified for this purpose.
- Do not fill the fuel tank to the maximum level.
- Do not smoke or approach the machine with a flame when the fuel tank is open or is being filled.
HYDRAULICS
- Any work on the load handling hydraulic circuit is forbidden except for the operations described ( MAINTENANCE).
- Do not attempt to loosen unions, hoses or any hydraulic component with the circuit under pressure.
IMPORTANT
BALANCING VALVE: It is dangerous to change the setting or remove the balancing valves or safety valves which may be fitted to your machine cylinders.
The HYDRAULIC ACCUMULATORS which may be fitted on your machine are pressurized units. Removing them and their pipework is dangerous.
These operations must only be performed by approved personnel (consult your dealer).
ELECTRICITY
- Do not short-circuit the starter relay to start the engine. If the forward/reverse selector is not in neutral and the parking
brake is not applied, the machine may suddenly start to move.
- Do not place metal items on the battery.
- Disconnect the battery before working on the electrical circuit.
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
Need help?
General