1 - 25
WELDING
- Disconnect the battery before any welding operations on the machine.
- When carrying out electric welding work on the machine, connect the negative cable from the equipment directly to
the part being welded so as to avoid very high current passing through the alternator.
- Never carry out welding or work which gives off heat on an assembled tire. The heat would increase the pressure which
could cause the tire to explode.
- If the machine is equipped with an electronic control unit, disconnect it before starting to weld so as to avoid the risk of
causing irreparable damage to electronic components.
IMPORTANT
Before carrying out any electric welding on the machine:
- Disconnect both battery terminals.
- The control screen input plug inside the driver’s cab must be disconnected.
- Also disconnect the 2 electronic box supply cables.
Failure to obey these instructions risk to damage the electrical and electronic components and would cancel the contractual guarantee.
WASHING THE MACHINE
- Clean the machine or at least the area concerned before any intervention.
- Remember to close and lock all accesses to the machine (doors, windows, cowls, etc.).
- During washing, avoid the articulations and electrical components and connections.
- If necessary, protect against penetration of water, steam or cleaning agents, components susceptible of being damaged,
particularly electrical components and connections and the injection pump.
- Clean the machine of any traces of fuel, oil or grease.
TRANSPORTING THE MACHINE
IMPORTANT
Transporting the machine involves real risks for the operator and others involved.
Towing, slinging or transporting the machine ( MAINTENANCE: OCCASIONAL OPERATION).
647866 M1 (A012021)
TMT ... K ST5 S1
To Next Page
Loading...
Need help?
General