Manitou TMT 25 I K ST5 S1 User Manual

1 - 26
PROLONGED MACHINE SHUTDOWN
INTRODUCTION
The following recommendations are intended to prevent the machine from being damaged when it is withdrawn from service
for an extended period.

IMPORTANT

Procedures to follow if the machine is not to be used for a long time and for starting it up again afterwards must be performed by your dealership.
This period of long-term stoppage must not exceed 12 months.
After 12 months, repeat the procedures for putting the machine back into service and long-term shutdown.
PREPARATION OF THE MACHINE
- Clean the machine thoroughly.
- Check and repair any fuel, oil, water or air leaks.
- Replace or repair any worn or damaged parts.
- Wash the painted surfaces of the machine in clear and cold water and wipe them.
- Touch up the paintwork if necessary.
- Shut down the machine ( OPERATING INSTRUCTIONS UNLADEN AND LADEN).
- Make sure the boom cylinder rods are all in retracted position.
- Release the pressure in the hydraulic circuits.
PROTECTING THE ENGINE
- Contact your dealer to obtain the procedure for protecting the inside of the engine.
- Fill the tank with fuel (
 MAINTENANCE: 10H - DAILY MAINTENANCE).
- Empty and replace the coolant ( MAINTENANCE: 1,000H - PERIODIC MAINTENANCE).
- Leave the engine running at idling speed for a few minutes, then switch off.
- Replace the engine oil and oil filter ( MAINTENANCE: 500 HOURS - PERIODIC MAINTENANCE).
- Run the engine for a short time so that the oil and cooling liquid circulate inside.
- Disconnect the battery and store it in a safe place away from the cold, after charging it to a maximum.
- Block the outlet with waterproof adhesive tape.
- Remove the drive belts and store them in a safe place.
- Disconnect the engine cut-off solenoid on the injection pump and carefully insulate the connection.
MACHINE PROTECTION
- Set the machine on axle stands so that the tires are not in contact with the ground and release the parking brake.
- Protect the cylinder rods, which will not be retracted, from corrosion.
- Wrap the tires.
NOTE: If the machine is to be stored outdoors, cover it with a waterproof tarpaulin.
RETURNING THE MACHINE TO SERVICE
- Remove the waterproof adhesive tape from all the holes.
- Refit and reconnect the battery.
- Remove the protection from the cylinder rods.
- Carry out daily maintenance ( MAINTENANCE: 10H - DAILY MAINTENANCE).
- Put the handbrake on and remove the axle stands.
- Empty and replace the fuel and replace the fuel filter ( MAINTENANCE: 500 HOURS - PERIODIC MAINTENANCE).
- Refit and set the tension in the drive belts ( MAINTENANCE: 500 HOURS - PERIODIC MAINTENANCE).
- Turn the engine over with the starter, to allow the oil pressure to rise.
- Reconnect the engine cut-off solenoid.
- Lubricate the machine completely ( MAINTENANCE: 50H - WEEKLY MAINTENANCE).

IMPORTANT

Make sure the area is adequately ventilated before starting up the machine.
- Start up the machine, following the operating and safety instructions ( OPERATING INSTRUCTIONS UNLADEN AND
LADEN).
- Run all the boom's hydraulic movements, concentrating on the ends of travel for each cylinder.
647866 M1 (A012021) TMT ... K ST5 S1

Manitou TMT 25 I K ST5 S1 Specifications

General

Brand	Manitou
Model	TMT 25 I K ST5 S1
Category	Forklifts
Language	English