28 Part Number 80-1479-3 10/10
ICE CUBE THICKNESS CHECK
The ice cube thickness is factory-set to maintain the
ice cube thickness at the proper size and weight.
Allow the ice machine to operate for three complete
cycles. The cubes should have a small dimple in the
center.
Cycle times vary, according to surrounding air and
water inlet temperatures.
If cubes are not full (large dimple), turn evaporator
thermostat one increment towards the right to increase
cube size. Allow ice machine to complete three cycles,
then check cubes.
If cubes are too full, (no dimple), turn evaporator
thermostat one increment towards the left to decrease
cube size. Allow ice machine to operate three
complete cycles, then check cubes.
Ice Cube Adjustment
To Next Page
Need help?
General