Mannesmann VDO E-Tacho 1323.02 - English

Table of Contents
© Mannesmann VDO AG 3
1 Prerequisites of the System........................................................ 4
2 Preparations for the Programming............................................ 6
2.1 Connection MTC 1602.04 to the E-Tacho ...................................... 6
2.1.1 Start Programming Procedure MTC 1602.04 .................................. 7
2.2 Connection ATC 1601.26 to the E-Tacho ....................................... 8
2.2.1 Start Programming Procedure ATC 1601.26................................... 9
2.3 Connection STC 1601.25 to the E-Tacho...................................... 10
2.3.1 Start Programming Procedure STC 1601.25 ................................. 11
3 Programming procedure........................................................... 12
3.1 v-Adjustment................................................................................ 13
3.2 Distance Counter Adjustment....................................................... 14
3.3 Drive-Stop Signal Adjustment ....................................................... 15
3.4 Versions Adjustment .................................................................... 16
3.5 Software Version Display .............................................................. 17
4 Test Speed Display .................................................................... 18
4.1 Pulling down the ”Variable Speed“ Menu .................................... 19
4.1.1 MTC 1602.04............................................................................... 19
4.1.2 ATC 1601.26................................................................................ 20
4.1.3 STC 1601.25 ................................................................................ 20
4.2 Operational Procedure Variable Speed.......................................... 21
5 Error Recovery ........................................................................ 22