Mannesmann VDO E-Tacho 1323.02 - Start Programming Procedure STC 1601.25

2.3 Connection STC 1601.25 to the E-Tacho
© Mannesmann VDO AG 11
2.3.1
Start Programming Procedure STC 1601.25
After having switched on the STC, the program starts
automatically, and the initial menu appears.
Display mask Display contents Input Programming procedure
1a
Initial menu:
Move the cursor beyond this display
mask to the next mask.
1b
Pull down the ”Programming“
menu and ...
confirm.
The menu item STC programs is displayed.
1a
Move the cursor beyond this display
mask to the next mask.
1b
Pull down the “E-TACHO“ menu
and ...
confirm.
The main menu E-Tacho programming with the possible
subprograms is displayed.
➥
Further steps see chap. 3 Programming Procedure.