102
System Setup
Setting items Setting details
GUI
(Continued)
NET/USB : Set the NET/USB screen display time when the input source
is “NET/USB”.
•Always : Show display continuously.
•30s : Show display for 30 seconds after operation.
•10s : Show display for 10 seconds after operation.
•OFF : Turn display off.
iPod : Set the iPod screen display time when the input source is
“USB/iPod”.
•Always : Show display continuously.
•30s : Show display for 30 seconds after operation.
•10s : Show display for 10 seconds after operation.
•OFF : Turn display off.
Tuner : Set the tuner screen display time when the input source is
“TUNER”.
•Always : Show display continuously.
•30s : Show display for 30 seconds after operation.
•10s : Show display for 10 seconds after operation.
•OFF : Turn display off.
Zone Rename
Change the display title of
each zone to one you prefer.
•Up to 10 characters can be input.
•For character input, see page83.
Display
Set the display on/off
setting.
ON : Display is always on.
Auto OFF : Display is off except when showing the status display.
OFF : Display is always off.
•This can also be set by pressing DISP.
Each time
DISP is pressed, the setting is changed as shown below.
ON Auto Off
OFF
•If DISPLAY on the main unit is pressed, the
same function as with the remote control unit
can be obtained.
Setting items Setting details
GUI
Make the settings related to
displays on the TV screen.
Screensaver : Make screensaver settings.
•ON : The screensaver is activated during
menu display, NET/USB, iPod or Tuner screen
display if no operation is performed for an
approximately 5-minute continuous period.
When you press uio p, the screensaver is
cancelled and the screen before that screen
saver started is displayed.
•OFF : Screensaver is not activated.
Format : Set the video signal format to be output for the TV you are using.
•NTSC : Select NTSC output.
•PAL : Select PAL output.
“Format” can also be set by the following procedure. However, the menu
screen is not displayed.
1. Press and hold the main unit’s ZONE SELECT and STATUS for at least 3
seconds.
“Video Format” appears on the display.
2. Press the main unit’s INTERNET RADIO or ONE TOUCH PLAY and set
the video signal format.
3. Press the main unit’s PURE DIRECT to complete the setting.
NOTE
When a format other than the video format of the connected TV is set, the
picture will not be displayed properly.
Text : Display the details of operation when switching surround mode,
input mode, etc.
•ON : Turn display on.
•OFF : Turn display off.
Master Volume : Display the master volume during adjustment.
•Bottom : Display at the bottom.
•Top : Display at the top.
•OFF : Turn display off.
When the master volume display is hard to see when superimposed
on movie subtitles, set to “Top”.
To Next Page
Loading...
