36
Tuning in radio stations
RT (Radio Text)
RT allows RDS stations to send text messages that appear on the
display.
“RT” appears on the display when radio text data is received.
1
Press TUNER twice to switch the
input source to “TUNER”.
2
Press SEARCH/INFO to select
“RT”.
TUNER
[
MEMORY
]
Band
Memory
[
T.MODE
] Mode[BAND]
[
PRESET+/-
] Preset
Tuning[
TUNING+/-
]
[
SEARCH
] Search
RDS
RDS station
Program category
Traffic info
ON
RDS
PTY
TP
RT
[
SEARCH
] SearchMode
FM 90.10MHz
•While receiving an RDS broadcast station, the text data broadcast
from the station is displayed.
•To turn the display off, press o p.
•If no text data is being broadcast, “NO TEXT DATA” is displayed.
nTuner (FM/AM) operation
Operation buttons Function
AMP MENU Amp menu
SHIFT/TOP MENU Preset channel block selection
SEARCH/INFO Direct frequency tuning / RDS search
uio p
Cursor operation
ENTER Enter
RETURN Return
T.MODE Switch search modes
BAND FM/AM switching
0 – 9
Preset channel selection (1 – 8) /
Direct frequency tuning (0 – 9)
MEMORY Preset memory registration
TV Z / X
TV power on/standby
(Default : marantz)
TV INPUT Switch TV input (Default : marantz)
TUNING +, – Tuning (up/down)
PRESET +, – Preset channel selection / RDS search
Switching the tuning increment
The tuning increment factory settings are 9 kHz for AM, and 0.05 MHz
for FM.
ON/STANDBY
PURE DIRECT
STATUS
1
While pressing down PURE DIRECT and STATUS,
insert the main unit power plug into the wall socket.
“AM9/FM50” appears on the display.
2
Press STATUS.
“AM10/FM200” appears on the display, and the tuning
increment is switched to AM and FM are 10 kHz and 0.2 MHz.
3
Press PURE DIRECT.
4
Press ON/STANDBY.
•The tuner preset memory will be cleared if this operation is
performed.
•This setting will not revert to the default values even when the
microprocessor is reset.
To Next Page
Loading...
