Marantz SR5008/U1B - Page 79

Sound mode
Surround Parameter
Tone
z
7
Audyssey
M-DAX
z
10
PRO LOGIC
g
/
g
x Music mode only
NEO:6 Music
mode only
Panorama Dimension Center Width Center Image
MultEQ® XT
z
8
Dynamic EQ
z
9
Dynamic
Volume
z
9
DIRECT/PURE DIRECT (2-channel)
z
5
DIRECT/PURE DIRECT (Multi-
channel)
z
5
STEREO
S S S S S
MULTI CH IN
S S S S
DOLBY PRO LOGIC
g
z
S S S S S
DOLBY PRO LOGIC
g
x
S S S S S S S S
DOLBY PRO LOGIC
g
S S S S S S S S
DTS NEO:6
S S S S S S
DOLBY DIGITAL
S S S S
DOLBY DIGITAL Plus
S S S S
DOLBY TrueHD
S S S S
DTS SURROUND
S S S S
DTS 96/24
S S S S
DTS-HD
S S S S
DTS Express
S S S S
MULTI CH STEREO
S S S S S
VIRTUAL
S S S S S
z
1 This item can be selected when a Dolby TrueHD signal is played.
z
2 This item can be selected when a Dolby Digital or DTS signal is played.
z
3 This item can be selected when a Dolby Digital or DTS signal or DVD-Audio is played.
z
4 This setting is available when the set sound mode name contains “+PL
g
z”.
z
5 During playback in PURE DIRECT mode, the surround parameters are the same as in DIRECT mode.
z
6 Audio is output when “Subwoofer Mode” in the menu is set to “LFE+Main”.
z
7 This item cannot be set when “Dynamic EQ” is set to “On”.
z
8 This item cannot be set when Audyssey® Setup (Speaker Calibration) has not been performed.
z
9 This item cannot be set when “MultEQ® XT” is set to “Off” or “Graphic EQ”.
z
10 This item can be set when the input signal is analog, PCM 48 kHz or 44.1 kHz.
79
www.audiodna.sk