Mark 7 APEX 10 - Table of Contents

2
Mark 7® Reloading APEX 10 User Manual version 1.0, Copyright 2021
All rights reserved
Table of Contents
Table of Contents ......................................................................................................................................... 2
Important Safety Instructions ................................................................................................................... 3
Set-Up Procedures
1. Package contents .................................................................................................................................. 4
2. Unpacking instructions ......................................................................................................................... 6
3. Installing Baseplate Riser Spacers ......................................................................................................... 7
4. Mounting to workbench and Handle installation ................................................................................. 8
5. Case Feeder Installation ...................................................................................................................... 10
6. Case Feeder Adapter and Drop Tube Assy installation ....................................................................... 13
7. Case Feeder Droptube and Spring Assy .............................................................................................. 14
8. Primer Tube Stack Assy and Low Primer Alarm .................................................................................. 15
9. Powder Measure installation .............................................................................................................. 17
10. Bullet Feeder installation and setup ................................................................................................. 18
11. Tool Head Recommended Die positions ........................................................................................... 19
Operating Instructions:
1. Case feed - Sizing Decapping ............................................................................................................. .20
2. Swage setup ....................................................................................................................................... .21
3. Priming seating/sizing ........................................................................................................................ .22
4. Case Neck Expansion .......................................................................................................................... .24
5. Powder Measure Die Height and Powder Charge adjustment .......................................................... .24
6. Setting up Mr.Bulletfeeder and Bullet Drop assy (Not Included) ...................................................... .25
7. Bullet Seating/Crimping setup ........................................................................................................... .26
Mark 7 APEX 10
TM
Recommended Maintenance ...................................................................................... 27
Shellplate Indexing adjustments ............................................................................................................... 30
Tool Head Removal, Shell Plate Change, Primer Size Change, Swage Rod Change…….…………………………32
Storage Recommendations, Troubleshooting ........................................................................................... 35
Read this manual. Understand all safety and operating instructions. Failure to comply
with the warnings and instructions may result in serious injury, illness or even death.