Mark 7 APEX 10 - Unpacking instructions

6
Mark 7® Reloading APEX 10 User Manual version 1.0, Copyright 2021
All rights reserved
Unpacking instructions:
Remove the APEX 10
TM
Press Core and place on a clean work surface.
WARNING – The APEX 10 is shipped with the Tool Head in the down position secured with a
zip tie. The Tool Head is spring loaded with a heavy-duty spring. Before cutting the zip-tie
place an 11/16” wrench on the main shaft to secure the press and gently raise the Tool Head after the
zip tie has been cut.
Figure 1: Cutting Zip tie securing Tool Head
11/16” Wrench
Location