Once the main unit is unpacked and placed on a workbench the APEX 10
TM
press can be setup a fitted
with the accessories. We recommend the following setup order:
1. Installing Base Plate Risers Spacers ....................................................................................................... page 7
2. Mounting to workbench and Handle Installation ................................................................................. page 8
3. Case Feeder and Pole Installation ....................................................................................................... page 10
4. Case Feeder Adapter and Drop Tube Assy Installation ....................................................................... page 13
5. Installing Primer Tube Stack and Low Primer Sensor .......................................................................... page 15
6. Powder Measure Installation .............................................................................................................. page 17
7. Mr. Bulletfeeder Installation and Setup .............................................................................................. page 18
1. Installing Base Plate Risers spacers
Thread in the 4 baseplate risers into the bottom of the press. Apply grease to the threads for easy
installation.
Figure 2: Installing Baseplate Riser Feet
To Next Page
Loading...
