Storage Recommendations
The following is the proper procedure for storage after a session of use:
1. Ensure that the shell plate is clear of any brass.
2. Remove powder and primers from the press.
3. Check the need for lubrication after every session and apply it as necessary at the key
lubrication points outlined in the user manual. Insufficient lubrication creates a potentially
dangerous situation and may lead to unreliable results
4. Turn off the power to the case feeder and the bullet feeder
5. Keep light weight oil on all metal surfaces.
Troubleshooting
Refer to the knowledge base section on our website under SUPPORT for troubleshooting articles
relating to setup and operation.
http://www.markvii-loading.com/
Mark 7 ® Digital Community at www.markvii-loading.com
Please contact us for technical support
Phone: 1-888-462-7577
Hours: 8:30am-5:00pm, ET, M–F
To Previous Page
Loading...
