Figure 27: No ejected Primer Notification
3. As with all sensors the decapping sensor can be enabled or disabled on the sensors screen.
4. During operation the optical sensor may become dirty and require cleaning. The following
notification box MAY appear when cleaning is required. In either case we recommend cleaning
and spraying down the spent primer hole with compressed air every few thousand rounds.
Figure 28: Sensor Obstructed Cleaning required Message
WARNING – cleaning intervals of the Mark 7® DecapSense® will vary dramatically based upon many
factors. WE SUGGEST CLEANING THE MARK 7® DecapSense™ AS OFTEN AS PRACTICAL – IT IS UP-TO
YOU TO ENSURE THE SENSOR IS CLEAN.
This is a product that is designed to improve the safety of the reloading operation. NEVER RELY ON THE
DECAPPING SENSOR. You must monitor its use – ALWAYS. Always be close to your machine and
available to stop the machine if it needs to be stopped
To Next Page
Loading...
