M6 System | V4 | Introduction and Presentation
Equipment List
Here are the hardware and software you need to install a M6 system.
Receiver (M6REC)
• 2 Mx receivers
• 4 Mx hydrophone junction boxes (ref. 46-055-01)
• 2 CAT5e network cables
• 2 Ethernet connector kits
• 2 Mx hardware kit (mounting screws and ground straps)
Computer (PC-0-04)
• 1 Mac Pro computer (quad-core)
• 1 wireless trackball mouse
• 1 Mac Pro power cord
• 2 Thunderbolt to HDMI/VGA/DVI adapter
• 1 Ethernet cable for PoE switch
• 1 Scala software dongle
Other hardware
1 PoE switch (ref. TP-Link TL-SG1008PE)
Optional equipment (not included)
• 1 to 6 monitors
• 1 Uninterruptible Power Supply (UPS) to prevent problems if the mains power fails
(recommended). Size: 500VA.
• 1 to 2 additional hydrophone junction boxes, for 1 to 2 additional hydrophones.
• 1 test hydrophone that you can keep on board and connect to the receiver to do functional tests.
• 1 NMEA multiplexer to receive NMEA data and display them in Scala: ShipModul MiniPlex-3E-
N2K if using NMEA2000 and NMEA0183 or Miniplex-3E if using only NMEA0183.
• 1 Ethernet switch, if you are connected to the internet and to an NMEA multiplexer.
• If using Mosa on a tablet computer: refer to Marport sales offices to know the recommended
model.
| 10
To Next Page
Loading...
