Marport M6 - Configuring Scala

M6 System | V4 | Installation
If you do not select Plain Text, messages will not be received by the multiplexer.
Note: Messages in plain text longer than 61 characters will not be received by the
multiplexer.
Configuring Scala
You need to configure Scala software to receive and display the NMEA data received on the
multiplexer.
About this task
Important: You cannot use Scala and configure the multiplexer on MPX-Config3 at the same
time: MPX-Config3 software uses UDP channel to transmit and receive commands to the
MiniPlex multiplexer. This channel needs to remain exclusive during the configuration of the
multiplexer.
Procedure
1.
Open Scala.
2.
From the top left corner of the screen, click Menu > Settings.
3.
Under the tab NMEA Inputs, click Add.
4.
Select UDP and enter 10110 as port.
5.
Click OK.
6.
In Sensor Data section in the control panels, check the activity of data received in the NMEA
tab.
| 60