M6 System | V4 | Installation
Installation
Read this section to learn how to connect and configure the equipment of the M6 system.
Installing the System
Marport technicians or dealers need to connect the different components of the system.
About this task
Note: The system is installed by Marport or by a dealer. If there is a problem, you can read
these installation steps to check the system installation.
Procedure
1.
Check that you have all the items needed for the installation (See Equipment List on page 10)
2.
Install the hydrophones and their cables, or find the cables from hydrophones that have already
been installed.
3.
Route the hydrophone cables toward the junction boxes.
4.
Install the receivers in a dry and clean area, as close as possible to the hydrophones. If the
receivers are in a closed environment, make sure it is enough ventilated and that the ambiant
temperature does not exceed 55 °C (131 °F).
Note: Make sure that the cables from the junction boxes are long enough to reach the
receivers.
5.
Install the Mac pro in a dry and ventilated area, without dust, in the wheelhouse.
6.
Install the monitor(s).
7.
Install the loudspeakers, if applicable.
8.
Connect the Mac pro and receivers according to Mac Pro Cabling on page 16 and Mx Receiver
Cabling on page 15.
9.
You can switch on the computer.
10.
Configure the networks and the receivers.
11.
Connect the hydrophone cables to the junction boxes according to Hydrophone Cabling on page
19 and connect the junction boxes to the hydrophone connectors on the receivers.
12.
When adding sensors to the system, refer to the Appendix A: Frequency Plan on page 73 to
help you allocating frequencies.
| 14
To Next Page
Loading...
