Marport M6 - Displaying Data on Scala

M6 System | V4 | Installation
5.
On Scala receiver page, complete Quality (3) settings according to the up and down settings:
UP DOWN Available quality settings on Scala
Yes No Worst / Medium / Best
No ≤ 150 m Worst / Medium / Best
Yes ≤ 150 m Worst / Medium*
Yes/No > 150 m Worst
Important: *Displayed as Best in TE SC application.
6.
Click Apply.
Results
The sensor is added to Marport receiver.
Displaying Data on Scala
About this task
Scala can only receive echogram data from the TE SC sensor. The other data (distance to bottom
and opening) are automatically measured by Scala.
Important: TE SC sensor has a blind zone of 1.4 m.
Procedure
1.
TE SC sensor data appears under the name Trawl Explorer SC in the control panels, in Sensors
Data. To display the echogram:
a)
Click Menu
> Customize and enter the password eureka.
b)
Click + hold Range of Sonar Data and drag it to a page.
2.
To have change colors:
a)
Right-click the echogram and select Show Palettes.
b)
Right-click each of the palette scales and select NC42ScanmarTrawleye.
c)
Drag bottom handles to 1 and upper handles to 99.
| 45