Marport M6 - Multiplexer Not Detected

M6 System | V4 | Installation
a)
In Gateway IP, enter the IP address of Ethernet 2 (in this example 192.168.70.4).
b)
Click OK.
7.
In MiniPlex Connection, click Connect.
If you have connected and correctly configured the baud speed of the device outputting NMEA
data, you should see incoming NMEA messages.
Multiplexer Not Detected
Before you begin
Make sure that your firewall does not block the multiplexer: in Apple Menu > System
Preferences > Security & Privacy > Firewall check that your firewall is off.
About this task
The multiplexer might not be detected because of a wrong configuration of the network settings,
such as a duplicate or illegal IP address. You need to assign a new IP address to the multiplexer.
Procedure
1.
Click Tools > MiniPlex-3E > Assign IP.
2.
In Assign IP Address dialog box:
a)
Enter the MAC address of the multiplexer (see label on topside of multiplexer). Fields must
be separated by dashes.
b)
Enter a valid IP address.
c)
Click OK.
| 57