Marport M6 - Multiplexer with Defined IP Address

M6 System | V4 | Installation
d)
Click OK.
In MiniPlex Connection, the Host IP address is updated.
7.
In MiniPlex Connection, click Connect.
If you have connected and correctly configured the baud speed of the device outputting NMEA
data, you should see incoming NMEA messages.
Multiplexer with Defined IP address
About this task
Do this procedure if:
• The multiplexer has already been given an IP address.
Procedure
1.
Connect the multiplexer to the computer or to the Ethernet switch.
2.
Open MPX-Config3 and from the toolbar click Tools > MiniPlex-3E > Search.
The multiplexer is displayed. You can see its IP address (192.168.70.2).
| 55