Marport M6 - Page 55

M6 System | V4 | Installation
f)
Click Apply.
4.
Open MPX-Config3 and from the toolbar click Tools > MiniPlex-3E > Search.
The multiplexer is displayed. Its IP address is also an auto-IP address that you need to change.
Trouble: If the multiplexer is not displayed: wait for a few seconds, then try again. It
may take a few minutes to recognize the auto-assigned IP address.
5.
Select the IP address then click OK.
6.
Click Tools > MiniPlex-35 > Network Setup.
a)
In IP Address, enter an IP address beginning by the same first 3 sets of numbers as in
Ethernet 2 IP address, such as 192.168.70.2.
b)
In Netmask, enter 255.255.255.0.
c)
In Gateway IP, enter Ethernet 2 IP address: 192.168.70.1.
| 54