M6 System | V4 | Installation
Active Hydrophone
We recommend the following wiring for the installation of the active hydrophone NC-1-07.
Note: To be able to receive water temperature from Marport hydrophones, on M3, M5 and
M6 systems connect to the NTC hydrophone input H1 or H2. On M4 system connect to the
hydrophone input 1 or 2 using an NMEA converter junction box (P/N: NC-2-TEMP).
If not using the junction box, wire directly the hydrophone to the cable 22-1265-01 the following
way:
1. Wire / 2. Heat shrink / 3.
Welding point
| 26
To Next Page
Loading...
