Marport M6 - Adding Temperature Data from the Hydrophones to the System

M6 System | V4 | Installation
Adding Temperature Data from the Hydrophones to the System
You can add the hydrophone to the receiver as a sensor in order to display in Scala the temperature
of the water surface.
Before you begin
Important: In order to receive temperature data, make sure the hydrophone is connected
to an NTC input on the receivers or is connected using an NMEA converter junction box. See
Connecting the Hydrophone to the Receiver on page 40 for guidelines.
Procedure
1.
From Scala, click Menu > Expert Mode and enter the password copernic.
2.
Click Menu > Receivers.
3.
From the left side of the receiver page, click Sensors.
4.
Under Add Sensor Product:
a)
Select Hydrophone in the Product Category menu.
b)
In the Product Name menu, select NMEA temperature if using an NMEA converter junction
box, or NTC temperature if the hydrophone is connected to an NTC input.
c)
In Hydrophone Location, select the number of the receiver's port on which the hydrophone
is connected.
d)
Click Add Sensor.
Results
The water temperature is displayed in Scala, in the control panels, under Sensors Data.
| 41