Marport M6 - Connecting the Hydrophone to the Receiver

M6 System | V4 | Installation
is activated on your system, you can read all TE SC sensor data (add as Trawl Explorer SC
Compatible).
b)
Simrad PI: add as PI Sensor, according to the type of sensor. Only data such as catch status,
depth, height,temperature and door spread can be read.
Results
You receive data from the hydrophone on both systems.
Connecting the Hydrophone to the Receiver
You need to connect the hydrophone to the receiver to be able to display sensor data received by the
hydrophones.
Procedure
• Connect the extension cable of the junction box to a hydrophone input on the receiver:
• Connect to the NTC hydrophone input H1 or H2 to be able to receive water temperature from
Marport hydrophones.
Note: H3 hydrophone input allows to receive water temperature from an NMEA
connection (Scanmar hydrophone or NMEA converter junction box). If you connect a
Marport hydrophone to H3 without NMEA converter, you will not have temperature
data from the hydrophone.
| 40