M6 System | V4 | Installation
Scanmar Hydrophone
We recommend the following wiring to connect a Scanmar hydrophone to a Marport system.
Scanmar hydrophones can be used with Marport receivers. They will show a lower current (5.5mA
instead of 8-9mA).
If you want to receive temperature data from this hydrophone, connect the junction box to H3 port
on M3 and M6 receivers or to H1 or H2 on an M4 receiver.
From Scala, Scanmar hydrophone can be added to the receiver as an active Scanmar hydrophone
(typical current consumption is 5-6 mA).
| 32
To Next Page
Loading...
