Marport M6 - Installing Shipmodul Miniplex Multiplexer (Optional); Installing MPX-Config3

M6 System | V4 | Installation
Installing ShipModul MiniPlex Multiplexer (Optional)
You can use a ShipModul MiniPlex multiplexer to receive simultaneously NMEA data from devices
such as GPS, compass or warp length sensor module and display them in Scala.
Note: Product reference: ShipModul MiniPlex-3E-N2K if using NMEA2000 and NMEA0183
or Miniplex-3E if using only NMEA0183
Important: ShipModul multiplexer cannot read NMEA messages longer than the standard
maximum length (82 characters), nor other format messages longer than 61 characters, nor
Marelec messages. Use another multiplexer if this is your case.
Installing MPX-Config3
You need to download and install MPX-Config3 software to configure the MiniPlex multiplexer.
About this task
MPX-Config3 software enables you to change the settings of the MiniPlex multiplexer.
Procedure
1.
To download MPX-Config3, go to: http://www.shipmodul.com/en/index.html. Then, click
Downloads > Utilities > MPX-Config3 for MiniPlex-3.
2.
From the Downloads folder, click the *.dmg file you downloaded.
3.
From the MPX-Config3 window that appears, copy MPX-Config3 application and paste it in the
Applications folder.
MPX-Config3 is installed on your computer and accessible via the Launchpad .
| 48