M6 System | V4 | Installation
Adding TE SC Sensor to the Receiver
You can add a TE SC sensor or a Marport TE SC compatible sensor to a Marport receiver.
Before you begin
To add this sensor to Marport receiver, you need to have:
•
Mx version 06.00.08 and above
•
TE SC option activated.
Adding the Sensor to the Receiver
Procedure
1.
Open Mx receiver page:
•
From Scala, click Menu > Expert Mode, then Menu > Receivers.
• Or enter the receiver IP address on Firefox web browser.
2.
From the left side of the screen where the system is displayed, click Sensors.
3.
In the page that appears:
a)
In Product Category select Trawl Explorer.
b)
In Product Name select Trawl Explorer SC Compatible.
c)
In Trawl Gear Location, indicate the location of the sensor on the trawl.
The sensor configuration page appears.
4.
Complete the settings according to the configuration you did on Mosa (for a Marport TE SC
compatible sensor) or on the TE SC programmer (TE SC sensor).
| 43
To Next Page
Loading...
