M6 System | V4 | Installation
1. Primary system: data
received on Simrad PI
system
2. Secondary system: data
received on Marport Mx
system.
3. Simrad PI receiver
4. Marport Mx receiver
5. Junction boxes
6. Use ceramic capacitors to
block power supply
7. Power from the junction
box to the hydrophone
8. Active hydrophone
Important: Use ceramic capacitors of 10 μF/ 25V. They are necessary to block power
supply.
Note: The primary system must be switched on in order for the secondary system to
work.
3.
On the Mx receiver page, add the hydrophone as passive, because there is no power supply from
this system.
4.
To add sensors from other systems on Scala:
a)
Scanmar: add in the same way as for a Marport sensor, according to the type of sensor.
Only data sent on boat/channel codes can be read by the Mx receiver. When TE SC option
| 39
To Next Page
Loading...
