Marport M6 - Page 57

M6 System | V4 | Installation
3.
Click Apple Menu > System Preferences > Network.
4.
Check that Ethernet 2 is on top of the network list. If not, click the tooth wheel icon at the
bottom of the list, select Set Service Order and drag Ethernet 2 to the top.
5.
In the list of networks, click Ethernet 2:
a)
In Configure IPv4, select Manually.
b)
In IP Address enter an address belonging to the same subnet as the multiplexer.
For example, if the multiplexer IP address is 192.168.70.2, enter an IP address such as
192.168.70.4.
a)
In Subnet Mask, enter 255.255.255.0.
b)
In Router, enter the same numbers as the IP address (in this example 192.168.70.4).
6.
In MPX-Config3 toolbar, click Tools > MiniPlex-35 > Network Setup.
| 56