Marport M6 - Page 47

M6 System | V4 | Installation
3.
By default, Scala applies filters on data to reduce interference. You can remove these filters to
have a display similar to a TE SC system:
a)
Right-click the echogram and click Filtered Data to deactivate it.
b)
Again, right-click the echogram and click Vertical Smoothing and Horizontal Smoothing to
deactivate them.
Smoothing and filters on
data activated (default)
Smoothing and filters
on data deactivated
a)
Click Menu
> Expert Mode and enter the password copernic.
b)
Click Menu > Receivers.
c)
From the system tree view on the left side of the page, click the sensor name.
d)
Click Configure next to Filter.
e)
In Echograms Filter, select Signal Interference Reduction Low.
Default display with filters
| 46