Lamp 11
Lamp
WARNING! Installing a lamp that is not specified in this manual may create a safety hazard and
damage the fixture. Replace the lamp immediately if it is deformed or in any way defective.
About the lamp
The smartMAC is designed for use with a Philips MSD 150/2 discharge lamp and is supplied with this lamp
installed. The Philips CDM-SA/T 150W/942 lamp is also approved for use with the smartMAC. These lamps
have the following specifications:
The Philips MSD 150/2 lamp has a color temperature of 8500 K, a color rendering index of approximately
70, and an average service life of 3000 hours at full intensity.
To reduce the risk of lamp failure or explosion, replace the lamp when it reaches the limit of its average
service life. Hours of lamp use are logged and can be read in the fixture’s display (see “Readouts” on
page 19).
Lamp replacement
WARNING! Wear safety glasses and gloves when handling discharge lamps.
Replacement lamps are available from your Martin dealer.
The clear bulb must be perfectly clean. Do not touch it with your fingers. Clean the lamp with an alcohol
wipe and polish it with a clean, dry cloth before installing, particularly if you accidentally touch the bulb.
To replace the lamp:
1. Disconnect the fixture from power and allow it to cool for at least 30 minutes.
Lamp Average life Color temp. CRI Luminous flux Efficacy
Philips MSD 150/2 3000 hours 8500 K 70 10 500 lm 70 lm/w
Philips CDM SA/T 150 9000 hours 4200K 95 14 000 lm 88 lm/w
Table 2: Lamp specifications
To Next Page
Loading...
Need help?
General
