Display messages 49
(Memory error) ...the EEPROM memory cannot be read.
Reset fixture.
If a pan/tilt error is displayed when you
attempt to reset the fixture, check that
the effects hatch is fully closed.
Upload new fixture software.
Contact Martin service personnel if
problem continues.
(Onboard programming error) ....there is a software programming error.
(RAM error) ....there is a RAM error.
(Color wheel error)
(Gobo wheel error)
...there is a malfunction in the color wheel or
gobo wheel positioning system.
(Feedback error pan)
(Feedback error tilt)
(Feedback error pan/tilt)
...the pan and/or tilt correction systems cannot
correct a loss of step (or there is a malfunction
in the pan/tilt monitoring circuit such as a
defective sensor). After a time-out, the head
stops in a random position.
(Pan time-out)
(Tilt time-out)
(Focus time-out)
...there is a malfunction in the position
indexing circuit for pan, tilt or focus. After the
time-out, the fixture will establish a
mechanical stop and continue to work,
although calibration will be imprecise.
(Head temperature error)
(Yoke temperature error)
...there is a malfunction in one of the
temperature sensing circuits.
-
(Driver error, drivers 1 - 7)
...one or more motor drivers fail.
(Display programming error) ...there is a display error.
Message Appears when... What to do
Table 6: Display messages
To Next Page
Loading...
Need help?
General
