model no. 046-0266-0 | contact us 1-800-689-9928
PROGRAMMING GUIDE – GARAGE DOOR OPENER
D. Erasing all the Remote Controls from Opener
Note: To erase any unwanted remote controls, first erase all remotes.
1. Press the [SET] button for 15 seconds.
When the LED display flashes “E”, release
the [SET]button.
2. Press the [SET] button again to confirm
all the programmed remotes have been
erased.
3. The dot in the LED display stays on
indicating that erasing the programmed
remotes has been successful.
ERASE WIRELESS
CONTROL
(FLASHING)
To Next Page
Loading...
Need help?
General
