Matrix SATATYA NVR0801X System Manual

Matrix SATATYA Devices Manual 209
Auto Configure
Local Device:
The Auto configure parameter is enabled by default. This gives a pop-up displaying a message whether to auto
configure all the searched cameras or not on system boot.
If Yes button is clicked, all the searched cameras in the configured network will gets automatically configured. You
can specify user-name and password with which cameras are to be added.
The user-name and password can also be set from the configuration settings of auto configure.
If No is clicked, the cameras will not be added.
When there is mismatch in the entered credentials and the credentials with which the camera is configured, then
the camera will not be added.
• Example: On system boot up, 3 cameras are auto discovered (2 are matrix cameras and 1 is Axis
camera).
The user is trying to auto configure all 3 cameras with User-name as Admin and Password as Admin which
are the default credentials of matrix camera. So, the two matrix camera will get added successfully and the
axis camera will not get added as the user-name and password of axis camera is root; admin.
Suppose If a user (Sheetal) is created and password is not set in the Matrix camera. And if you add this
camera in SATATYA device with the user-name and password as Sheetal; then on Auto configure request;
password will get set on the camera and the live stream will start on the local display.

Matrix SATATYA NVR0801X Specifications

General

Brand	Matrix
Model	SATATYA NVR0801X
Category	DVR
Language	English