214 Matrix SATATYA Devices Manual
Advanced Settings
Integrate with SAMAS: Check the box to integrate the SATATYA device with SAMAS.
• IP Address: Specify the IP address of the Recording Server to which the SATATYA Device will be added.
If Auto addition is enabled in SAMAS then device will be added automatically.
• Port: Specify the “Auto Add Device Port” as specified in SAMAS Recording Server Manager.
Integrate with COSEC: Enable to integrate the SATATYA device with COSEC.
Start Live View: Enable or Disable the Start Live View check box to start or stop the live view of the cameras
assigned in the live view layout page of the Local Client respectively. By default, this checkbox is disabled.
This checkbox is available both in Local Client as well as in Device Client.
In Local Client, the Live View checkbox is available with two radio buttons as shown below:
On Enabling the Live View checkbox, you can select either Real Time or Smooth view option.
• Select Real Time, to view the live view at the real time.
• Select Smooth view, to minimize the jerks in the live view which may occur due to some network problem.
Now, suppose the Start Live View check box is disabled in General settings, now when the system will boot up, the
Auto-configure pop up will appear to the user in the Local Client.
Case1: If user clicks No in Auto-configure pop up:
• If the user clicks on No button in Auto-configure pop up, then the pop up asking “Would You like to start
live view of cameras” will appear to the user. Click Yes to start the live view.
To Next Page
Loading...
Need help?
General
