Matrix SATATYA Devices Manual 215
Case2: If user clicks Yes or Close the Auto-configure pop up:
• If the user clicks on Yes or Close the Auto-configure pop up, then in 10 seconds this pop up will appear
again and after 5 minutes the pop up of “Would You like to start live view of cameras” for live view will
appear and the auto configure pop shall get closed automatically.
The pop up of “Would You like to start live view of cameras” will appear to the user just after the
other pop ups (HDD clean up, HDMI resolution, if configured) appear.
Local user would need the login credentials to change the configuration of live view.
HDMI resolution pop-up would not appear in NVRX series devices.
Click on Save once done.
When you connect one or more devices to a network through an IP sharing device, each device must
have a unique TCP port number for remote access to each unit from outside the LAN (Local Area
Network).
In NVRX variants, Network Acceleration option is provided for both Local and Device Client as shown below.
To Next Page
Loading...
Need help?
General
