Matrix SETU ATA211 V1 System Manual 149
Q.19 Can I change the configuration of ATA211 to factory default?
Ans. Yes. You can change the configuration to factory default. Please refer “Reinstate the Default Settings” for
this information.
Q.20 Can I select the SIP Account or FXO port to make OG call?
Ans. Yes. You can dial first the access code for the FXO, SIP1, SIP2 or SIP3 and then dial the required number
for OG call.
Q.21 Can I use the ATA211 for Least Cost Routing (LCR) application?
Ans. Yes. You can do this by selecting 'Dialed Number based Routing' for parameter 'OG Call Route' in Web
page for 'FXS Port' . After selecting option for routing, program in the Webpage 'Dialed Number Table', the
numbers to be dialed and corresponding SIP account or FXO port as Destination Route which is cheaper
for the call to be made.
Q.22 Can I route the Incoming calls on SIP to FXO?
Ans. Yes. You can configure suitable routing option for 'Route the Incoming Calls' in the Webpage 'SIP Account'.
Refer chapter “SIP Accounts”.
To Next Page
Loading...
Need help?
General
