30 Matrix SETU ATA211 V1 System Manual
Configuring ATA211 for Gateway functionality (Call Routing)
FXO to SIP routing:
• You can call to FXO port of ATA211 and dial the number. ATA will route this call using the SIP account
which is configured in ATA.
• To achieve this, ATA needs to be configured for the parameter 'Incoming call route' in the Web page 'FXO
Port'.
• Refer chapter “FXO Port” for the desired configuration.
FXO to desired port routing (dialed number based):
• You can also call to FXO port of ATA211 and dial the specific number. ATA will route the call to desired
destination route, based on the number dialed.
• To achieve this, ATA needs to be configured for the parameter 'Incoming call route' in the Web page 'Dialed
number Table'.
• Refer chapter “FXO Port” and “Dialed Number Table”.
FXO to fixed destination routing:
• You can call to FXO port of ATA211 and dial the number. ATA will route the call to the fixed destination
number, every time.
• To achieve this, ATA needs to be configured for the parameter 'Fixed Destination Number' in the Web page
'FXO Port'.
• Refer chapter “FXO Port”.
SIP to FXS or FXO routing:
• You can make call on the SIP account of ATA211and dial the number. ATA will route the call to destination
route; FXS or FXO depending upon the 'Number' for which the incoming call is received.
• To achieve this, ATA needs to be configured for desired Numbers and corresponding destination route in
the Web page Called Party Number Table.
• Refer chapter “Called Party Number Table”.
SIP to Fixed Destination Number:
• You can make call on the SIP account of ATA211and dial the number. ATA will route the Fixed Destination
Number.
• To achieve this, ATA needs to be configured for the option 'Route to fixed destination number through FXO'
and the desired number for the parameter 'Fixed Destination Number' in the web page 'SIP Accounts'.
• Refer chapter “SIP Accounts”.
Routing to FXO port using Auto PSTN Fall Back:
• If your SIP account does not get registered due to some reason, ATA can route the call through alternate
route of 'FXO Port'.
• To achieve this, ATA needs to be configured for 'Auto PSTN Fall Back' feature.
• Refer chapter “FXO Port”.
To Next Page
Loading...
Need help?
General
