Matrix
SIMADO GFX11 System Manual
21
Instruction for the Connecting Interfaces:
This section, describes the instruction on how to connect the Matrix
GFX11 to GSM network and telephone.
• Unpack the box. Get satisfied with the contents and the condition
of the parts. Refer to
Packing List. If parts are OK, proceed with
connection as shown below:
• Mount the GFX11, in a safe and convenient location where cables
for phone system and adaptor are accessible. For this
mechanical drawing can be used as a reference which is provided
at the end of chapter.
• Connect one end of telephone cable, RJ11 to FXS port and the
other end to analog telephone with CLI display.
• Insert a SIM card. Place the telephone at maximum possible
distance from the GFX11.
• Connect the antenna which is supplied with the product, to the
Antenna connector, on the side panel. Gently tighten the
connection, with a suitable spanner. If Antenna is with cable type,
fix it to the suitable location.
• Check the voltage from the power point from where the supply is
to be accessed. It should be between 90-265VAC, 47-65Hz.
Insert the DC output terminal of power adaptor into the ‘Power’
jack of the GFX11 and connect the power adaptor to a wall outlet
for AC Mains. Your GFX11 is now ready for switching ON.
Basic Steps for Configuration:
• Switch ON the power through ‘Adaptor’ and wait for LED’s to
attain normal state.
ABSOLUTETLY NEEDED !
• Ensure network availability
• Make sure that your GSM module is
registered with GSM network
• By default, you can call any number from the GSM port by
using analog phone.
• You can use the GFX11 for other features by programming
through the analog phone, for either System Engineer (SE) mode
or System Administrator (SA) mode.
• Enter the SE mode by: Lift the handset
Æ Dial Tone Æ #*-19-
1234. You get programming tone. Use this mode for basic
To Next Page
Loading...
Need help?
General
