Matrix
64
SIMADO GFX11 System Manual
Network Selection
What’s this?
• Many times it happens that the system is installed in a remote
place which is hilly or at a place where it is surrounded by
multistoryed buildings. In such case, the mobile user may not get
registered with a suitable network and his work is affected. Same
problem is faced when he is moving out of his home region. User
of mobile station (Handset) has the user interface on the LCD,
which shows, the name of the available network and he can
select the desired network. But such user interface is not
available in the SIMADO GFX11. The same purpose is served by
providing multiple network operator options based on their
specific network operator code. The subscriber can select the
network manually or automatically, for each mobile port. This is
known as Network Selection.
• If the subscriber is working in the area where, his home network
as well as other network coverage is also available, then he can
select the network manually such that he can restrict the extra
charges. Normally subscriber uses this mode when he is working
outside his home network.
• But if the subscriber is always busy with important business
matter, then he would like to get registered with any network
operator. He wants to make and receive calls, at any cost. For
such requirement he will use this feature, in Automatic Mode.
• User can select the frequency for SIMADO GFX11 as supported
by the country.
How it works?
• User can assign option for network selection, which will be
applicable for the GSM port.
• The feature works, when SIMADO GFX11 is powered ON or if the
port is NOT registered with network.
• Maximum 4 network operators can be programmed. In manual
mode mobile port starts to get registered with network operator,
as per order of programming with its network operator code. In
Automatic Mode, the GSM port gets registered with the network
operator as per field strength. If it doesn’t get registered till expiry
To Next Page
Loading...
Need help?
General
