Matrix simado gfx11 - Restart the System

Matrix
SIMADO GFX11 System Manual
71
Restart the System
What’s this?
The Matrix SIMADO GFX11 supports a command from the
programming mode to restart the system. This command gives
same effect as switching OFF the system and switching it ON
again. Many times it is difficult to physically walk to the system and
restart it. It is convenient if we could do the same from telephone
instrument. The SIMADO GFX11 offers facility to restart the system
by dialing a code.
How to use it?
Use following command to restart the system:
105-SE Password-#*
Where,
SE Password is a number string of 4-digits.
Important Points:
• Restart the system is same as switching it OFF and ON again.
This command does not alter any programming parameters.
• This password is also used to enter into programming mode.
Relevant Topic:
1.
System Security (Passwords) 80
=X=X=