Matrix simado gfx11 System Manual

Matrix
SIMADO GFX11 System Manual
55
GSM Port Parameters
What’s this?
• In order to interface with GSM network, the GSM port of SIMADO
GFX11 can be enabled/disabled, programmed for CLIR, enabled/
disabled for SMS notification, etc.
• This chapter explains which parameters are required to be
programmed for the GSM port.
• For frequency band selection, refer chapter
Network Selection.
How to program?
GSM port parameters can be programmed in the following
hierarchy:
Step 1: Enable/Disable the GSM port using the command 201.
Step 2: Program the CLIR mode using command 202.
Step 3: Enable/Disable the incoming SMS indication using the
command 203.
Step 4: Enable/Disable the Location Information Indication using
command 205.
Step 5: Program the receive gain using the command 271.
Step 6: Program the transmit gain using the command 272.
Step 1
GSM Port Enable/Disable
The GSM port can individually be enabled or disabled.
Use the following command to enable/disable the GSM port:
201-Code-#*
Where,
Code Meaning
0Disable
1 Enable
By default, the GSM port is enabled. When the GSM port is
disabled, it is still possible to receive incoming calls.
Step 2
Enable/Disable the CLIR on the GSM port
The CLIR on the GSM port can be enabled/disabled.

Matrix simado gfx11 Specifications

General

Brand	Matrix
Model	simado gfx11
Category	Gateway
Language	English