Matrix
SIMADO GFX11 System Manual
45
Default the Configuration
What’s this?
Every system comes with a pre-defined set of variables and
parameters. These pre-defined settings are called default settings.
The default value of each programmable parameter is mentioned in
respective section. If the default settings and values suit your
requirements then there is no need to program the system and
system will work according to the default settings.
How to use it?
Suppose the SE has programmed the system and changed the
values of parameters as required. Unfortunately the system does
not function as expected. Tracking the mistake may become
difficult and time consuming. In such cases the command to default
the configuration can be issued, which shall assign the default
values to all the programmable variables.
How to program?
Use following command to load the default configuration:
106-Reverse SE Password-#*
Reverse SE Password is a number string of maximum 4 digits.
By default, SE Password is 1234. Hence, Reverse SE password in
such case will be 4321.
Important Points:
• Please note that, this feature will not default the values of
parameters enabled/disabled by the Service Provider like CLIR,
Call Divert, SIM enable/disable, Call Progress Tones, Distinctive
Rings, etc.
• On giving this command, system restarts.
Relevant Topics:
1.
Programming the System through FXS Port 68
2.
System Security (Passwords) 80
=X=X=
To Next Page
Loading...
Need help?
General
