Maxell MP-WU9101B - Maintenance; Cleaning the Ventilation Inlet

67
Maintenance
►Before taking care of the ventilation inlet, make sure the
power cable is not plugged in, then allow the projector to cool sufciently. Before
taking care of the ventilation inlet, make sure to turn the projector off and to pull
out the power cable, then allow the inside of the projector to cool sufciently.
If you take care of the projector with the power cord connected, it could cause
a re or an electrical shock. If you handle the projector in a high temperature
state, it could cause a burn.
WARNING
Maintenance
If you nd something abnormal with the light source, contact your dealer or
service company.
Cleaning the ventilation inlet
It is recommended to check and clean the ventilation inlet periodically for
maintaining the ventilation inside of the projector and normal operation.
If a message prompts you to clean or check the ventilation inlet, or if the TEMP.
indicator lights in red, clean the ventilation inlet immediately.
1.
Turn the projector off and unplug the power cord. Allow the projector to cool
down sufciently.
2.
Use a vacuum cleaner on and around the ventilation inlet.
How to clean the ventilation inlet