72
Troubleshooting
Regarding the indicator (continued)
LIGHT LED
LED Display Projector Status Procedure
Off Laser is off
Flashing
Green Prepare to light laser
Red (Cycles of 6) Laser lit fail
On
Red Laser is end-of-life
Green Laser is on
TEMP. LED
LED Display Projector Status Procedure
Off No Problem
Flashing Red Temperature problem
If the problem occurs
again after retrying,
contact your dealer or
service.
• The time period of each step in the above LED blinking pattern is 0.5
seconds, e.g., for “Cooling / Warming up” state, the green LED will ON for 0.5
seconds, and then OFF 0.5 seconds, and then repeat the above LED pattern.
NOTE
Resetting all settings
When it is hard to correct some wrong settings, the FACTORY RESET function of
SERVICE item in OPTION menu (61) can reset all settings (except settings such
as LANGUAGE, LASER TIME, STANDBY MODE, and NETWORK) to the factory
default.
To Next Page
Loading...
