Operation
0000000141 - 002 - EN 28
We recommend slowly increasing the pressure of the drive air to keep the stress
on the gas booster components low during commissioning.
The stroke frequency of the booster is kept low this way. Otherwise, during the
ramp-up phase, until the required operating pressure is reached, operating
phases with very high cycle frequencies can occur.
6 Operation
6.1 Prerequisites for operation
Follow the manual and general drawing for the product.
In addition, the following conditions are required:
– The product must be free of damage.
– The product must be securely attached.
– The product is not exposed to any vibrations.
– The product is not exposed to any external heat or radiation sources.
– A risk assessment has been compiled for the system, and all basic health and
safety requirements have been met.
6.2 Normal, safe operation
WARNING
Risks of sustaining injuries are posed by improper handling of operating fluids!
Improper handling of operating fluids can lead to accidents resulting in severe in-
juries or death.
► Comply with the safety data sheets of the operating fluids.
► Dispose of operating fluid residues in an appropriate manner.
► Notify other people (for example: repair department) of hazardous operat-
ing fluids.
6.3 Abnormal situations during operation
Refer to the general system documentation for measures to consider or imple-
ment in case of abnormal operation.
To Next Page
Loading...