110
Controls in detail
Locking and unlocking
Global unlocking
Press button Πtwice.
All turn signal lamps flash once. The
locking knobs in the doors move up.
The anti-theft alarm system is
switched off.
Global locking
Press button ‹.
All turn signal lamps flash three
times. The locking knobs in the doors
move down. The anti-theft alarm sys-
tem is activated.
Restoring to factory setting
Press and hold buttons Œ and ‹
simultaneously for about six seconds
until battery check lamp 6 flashes
twice.
Checking the batteries
Press button Œ or ‹.
Battery check lamp 6 comes on
briefly to indicate that the SmartKey
batteries are in order.
!
If you can no longer lock or unlock
the vehicle with the SmartKey, then
either the batteries in the SmartKey
are discharged, the SmartKey is mal-
functioning or the vehicle batteries
are drained.
Check the batteries in the
SmartKey and replace them if nec-
essary ( page 429).
Use the mechanical key to unlock
the driver’s door (
page 423) and
trunk (
page 424).
Use the mechanical key to lock the
driver’s door (
page 423).
Have the vehicle batteries and
their connections checked
(
page 441).
If the SmartKey is malfunctioning,
contact an authorized Maybach
Studio.
i
If battery check lamp 6 does not
come on briefly during check, then
the SmartKey batteries are dis-
charged.
Replace the batteries (
page 429).
You can obtain the required batteries
at any authorized Maybach Studio.
i
If the batteries are checked within
signal range of the vehicle, pressing
button Œ or ‹ will lock or un-
lock the vehicle accordingly.
To Next Page
Loading...
