305
Controls in detail
Useful features
Programming or reprogramming the in-
tegrated remote control
Step 1:
Switch on ignition ( page 54).
Step 2:
If you have previously programmed
an integrated signal transmitter but-
ton and wish to retain its program-
ming, proceed to step 3. Otherwise,
press and hold the two outer signal
transmitter buttons 3 and 4 and re-
lease them only when the indicator
lamp 1 begins to flash after approx-
imately 20 seconds (do not hold the
button for longer than 30 seconds).
This procedure erases any previous
settings for all three channels and ini-
tializes the memory. If you later wish
to program a second and/or third
hand-held transmitter to the remain-
ing two signal transmitter buttons,
do not repeat this step and begin di-
rectly with step 3.
Step 3:
Hold the end of the hand-held re-
mote control transmitter 6 of the
device you wish to train approximate-
ly 2 to 5 in (5 to 12 cm) away from
the surface of the integrated remote
control located on the interior rear
view mirror, keeping the indicator
lamp 1 in view.
Step 4:
Using both hands, simultaneously
press the hand-held transmitter but-
ton 5 and the desired integrated sig-
nal transmitter button (2, 3 or 4).
Do not release the buttons until com-
pleting step 5.
The indicator lamp 1 on the inte-
grated remote control will flash, first
slowly and then rapidly.
i
Certain types of garage door openers
are incompatible with the integrated
opener. If you should experience dif-
ficulties with programming the trans-
mitter, contact an authorized
Maybach Studio, or call Maybach Cus-
tomer Assistance Center at
1-866-FOR-MAYBach (in the USA) or
1-888-881-6611 (in Canada).
i
For operation in the USA only:
This device complies with Part 15 of
the FCC Rules. Operation is subject to
the following two conditions:
(1) This device may not cause harmful
interference, and
(2) this device must accept any inter-
ference received, including inter-
ference that may cause undesired
operation.
Any unauthorized modification to
this device could void the user’s au-
thority to operate the equipment.
i
The indicator lamp 1 flashes the first
time the signal transmitter button is
programmed. If this button has al-
ready been programmed, the indica-
tor lamp will only start flashing after
20 seconds.
To Next Page
Loading...
