306
Controls in detail
Useful features
Step 5:
When the indicator lamp 1 flashes
rapidly, release both buttons.
Step 6:
Press and hold the just-trained inte-
grated signal transmitter button and
observe the indicator lamp 1.
If the indicator lamp 1 stays on con-
stantly, programming is complete
and your device should activate when
the integrated signal transmitter but-
ton is pressed and released.
Step 7:
To program the remaining two but-
tons, repeat the steps above starting
with step 3.
Rolling code programming
To train a garage door opener (or other
rolling code devices) with the rolling
code feature, follow these instructions
after completing the "Programming"
portion (steps 1 through 6) of this text.
(A second person may make the follow-
ing training procedures quicker and eas-
ier.)
Step 8:
Locate "training" button on the ga-
rage door opener motor head unit.
Exact location and color of the but-
ton may vary by garage door opener
brand. Depending on manufacturer,
the "training" button may also be re-
ferred to as "learn" or "smart" but-
ton. If there is difficulty locating the
transmitting button, refer to the ga-
rage door opener operator’s manual.
Step 9
Press "training" button on the ga-
rage door opener motor head unit.
The "training light" is activated.
You have 30 seconds to initiate the fol-
lowing step.
Step 10:
Firmly press, hold for two seconds
and release the programmed inte-
grated signal transmitter button
(2, 3 or 4).
Step 11:
Press, hold for two seconds and re-
lease same button a second time to
complete the training process.
Some garage door openers (or other roll-
ing code equipped devices) may require
you to perform this procedure a third
time to complete the training.
Step 12:
Confirm the garage door operation
by pressing the programmed inte-
grated signal transmitter button
(2, 3 or 4).
Step 13:
To program the remaining two but-
tons, repeat the steps above starting
with step 3.
i
If the indicator lamp 1 blinks rapidly
for about two seconds and then turns
to a constant light, continue with
programming steps 8 through 12 as
your garage door opener may be
equipped with the "rolling code"
feature.
To Next Page
Loading...
